Methane esterification in oleum

The reactions taking place during methane esterification in oleum were investigated. It was found that the primary products were methyl bisulphate and formaldehyde, which was subsequently oxidized to carbon dioxide. The catalyst, Pd or PtCl₄, was needed to activate methane and for its oxidation to the primary products. The formation of CO₂ was not a catalytic process. It was found that the addition of either carbon dioxide or ester into the reaction mixture did not slow down the reactions. Methane oxidation in oleum is an irreversible process, during which water is produced and subsequently consumed to give sulphuric acid by the reaction with sulphur trioxide. Presented at the 33rd International Conference of the Slovak Society of Chemical Engineering, Tatranské Matliare, 22–26 May 2006.     

活性炭表面固载十二硅钨酸的表征

活性炭表面固载十二硅钨酸的表征王新平，叶兴凯，吴越（中国科学院长春应用化学研究所，长春１３００２２）关键词硅钨酸，杂多酸，活性炭，负载型催化剂，表征由于杂多酸的优异催化性能，近年来其固载化的研究深受人们的关注［１］．活性炭是固载杂多酸较好的载体之一［...     

Palladium-catalyzed Suzuki-Miyaura couplings of potassium aryl trifluoroborates with 4-tosyloxycoumarins or 4-tosyloxyquinolin-2(1H)-one

Pd(PPh₃)₄ catalyzed Suzuki-Miyaura cross-coupling reactions of 4-tosyloxycoumarins or 4-tosyloxyquinolin-2(1H)-one with various potassium aryl trifluoroborates afforded the corresponding 4-substituted coumarins or 4-substituted quinolin-2(1H)-ones in good to excellent yield.     

Towards Single-component Molecular Conductor [Ni(dmit)_2] by Charge Disproportionation:2[Ni(dmit)_2]~(-0.5)[Ni(dmit)_2]+[Ni(dmit)_2]~-

It was commonly thought that a molecular conductor or semiconductor should be composed of at least two components to make the conducting component in partially charged state. However, this idea became questionable by the recent report of the single-component molecular conductor [Ni(tmdt)2]1 as well as several reports about single-component molecular semiconductors such as [Ni(ptdt)2]2 and [Ni(C10H10S8)2]3. In fact, as early as 1985, [Ni(dmit)2] as a by-product in synthesizing TTF[Ni(dmit…     

Methodology for the calculation of the potential of mean force for a cation-pi complex in water.

We report potential of mean force (PMF) calculations on the interaction between the p-sulfonatocalix[4]arene and a monovalent cation (Cs(+)). It has been recently shown from microcalorimetry and (133)Cs NMR experiments that the association with Cs(+) is governed by favourable cation-pi interactions and is characterized by the insertion of the cation into the cavity of the macrocycle. We show that the PMF calculation based upon a classical model is not able to reproduce both the thermodynamic properties of association and the insertion of the cation. In order to take into account the different contributions of the cation-pi interactions, we develop a new methodology consisting of changing the standard PMF by an additional contribution resulting from quantum calculations. The calculated thermodynamic properties of association are thus in line with the microcalorimetry and (133)Cs NMR experiments and the structure of the complex at the Gibbs free-energy minimum shows the insertion of the cation into the cavity of the calixarene.     

On the three-phase mass transfer with solid particles adhered to the gas-liquid interface

A heterogeneous, multi-layer mass transfer model is proposed for prediction of the effect of multi-layer packing of catalyst particles adhered to the gas-liquid interface. The behavior of the mass transfer rate with respect to the multi-layer packing, to the particle size and mass transfer coefficient without particles is discussed. It is shown that enhancement can be considerably increased by multi-layer packing compared to that of mono-layer packing, depending on the values of particle size and mass transfer coefficient. The predicted mass transfer rates using the proposed model was verified with experimental data taken from the literature. The model presented should be superior to that of published in the literature.     

A new enzyme model for enantioselective esterases based on molecularly imprinted polymers

An efficient enzyme model exhibiting enantioselective esterase activity was prepared by using molecular imprinting techniques. The enantiomerically pure phosphonic monoesters 4 L and 5 L were synthesized as stable transition-state analogues. They were used as templates connected by stoichiometric noncovalent interactions to two equivalents of the amidinium binding site monomer 1. After polymerization and removal of the template, the polymers were efficient catalysts for the hydrolysis of certain nonactivated amino acid phenylesters (2 L, 2 D, 3 L, 3 D) depending on the template used. Imprinted catalyst IP4 (imprinted with 4 L) enhanced the hydrolysis of the corresponding substrate 2 L by a factor of 325 relative to that of a buffered solution. Relative to a control polymer containing the same functionalities, prepared without template 4 L, the enhancement was still about 80-fold, showing the highest imprinting effect up to now. In cross-selectivity experiments a strong substrate selectivity of higher than three was found despite small differences in the structure of the substrate and template. Plots of initial velocities of the hydrolysis versus substrate concentration showed typical Michaelis-Menten kinetics with saturation behavior. From these curves, the Michaelis constant K(M) and the catalytic constant k(cat) can be calculated. The enantioselectivity shown in these values is most interesting. The ratio of the catalytic efficiency k(cat)/K(M), between the hydrolysis of 2 L- and 2 D-substrate with IP4, is 1.65. This enantioselectivity derives from both selective binding of the substrate (K(M)L/K(M)D=0.82), and from selective formation of the transition state (k(cat)L/k(cat)D=1.36). Thus, these catalysts give good catalysis as well as high imprinting and substrate selectivity. Strong competitive inhibition is caused by the template used in imprinting. This behavior is also quite similar to the behavior of natural enzymes, for which these catalysts are good models.     

Molecular Reorientational Dynamics of the Neat Ionic Liquid 1‐Butyl‐3‐methylimidazolium Hexafluorophosphate by Measurement of 13C Nuclear Magnetic Relaxation Data

The reorientational dynamics of the ionic liquid 1butyl‐3‐methylimidazolium hexafluorophosphate ([BMIM]PF₆) were studied over a wide range of temperatures by measurement of ¹³C spin–lattice relaxation rates and NOE factors. The reorientational dynamics were evaluated by performing fits to the experimental relaxation data. Thus, the overall reorientational motion was described by a Cole–Davidson spectral density with a Vogel–Fulcher–Tammann temperature dependence of the correlation times. The reorientational motion of the butyl chain was modelled by a combination of the latter model for the overall motion with a Bloembergen–Purcell–Pound spectral density and an Arrhenius temperature dependence for the internal motion. Except for C2 in the aromatic ring, an additional reduction of the spectral density by the Lipari–Szabo model had to be employed. This reduction is a consequence of fast molecular motions before the rotational diffusion process becomes effective. The C2 atom did not exhibit this reduction, because the librational motion of the corresponding C2? H vector is severely hindered due to hydrogen bonding with the hexafluorophosphate anion. The observed dynamic features of the [BMIM]⁺ cation confirm quantum‐chemical structures obtained in a former study.     

Intramolecular Dynamics and Molecular Structure of Europium(III) Chelate Complexes with Crown Ethers as Studied by NMR Spectroscopy

Earlier the intramolecular inversion of the 18-crown-6 molecules was found in the complex ion pairs [Ln(ptfa)₂ (18-crown-6)]⁺ [Ln(ptfa)₄]⁻ (H₂O)₄ where Ln = La(1), Ce (2), Pr (3), Nd (4), and ptfa is 1,1,1-trifluoro-5,5-dimethyl-2,4-hexanedione. In this work the peculiarities of the molecular structure and dynamics were studied for [Eu(ptfa)₂ (18-crown-6)]⁺ [Eu(ptfa)₄]⁻ (H₂O)₄ (5) by NMR spectroscopy techniques. Through VT-NMR spectra analysis the temperature dependence was obtained for the rate constant. The free energy ΔG^‡(320) of 18-crown-6 ring inversion activation was found to be 65 ± 5 kJ mol⁻¹ for 5 in CDCl₃. This result is comparable with the earlier data [S.P. Babailov and D.A. Mainichev: J. Inclusion Phenom. Macrocyclic Chem. 43, 187–193 (2002)] for complexes 2, 3, 4 in deuterated toluene (ΔG^‡(320)=65 ± 9, 64 ± 9, 64 ± 9 kJ mol⁻¹ respectively). It was found by relaxation NMR spectroscopy that the effective distance between Ln and protons of the crown molecule is 4.5 ± 0.2 Å. The analysis of structural parameters testifies that the crown ether and chelated anions are in the first coordination sphere of a Ln cation. Obtained geometrical parameters show that the complex cations of Eu, Ce and Pr have similar spatial structures.This revised version was published online in July 2005 with a corrected issue number.